LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2009 >> H3 Alpha >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Battery, Charging System And Starting System) >> Repair Instructions >> Generator Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Generator & Related Connectors
    GM1696891Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
  3. Remove the accessory drive belt. Refer to Drive Belt Replacement - Accessory .
  4. Disconnect the engine harness electrical connector (3) from the generator.
    5. Fig 2: View Of Battery Jumper Cable Terminal, Nut & Bolt
    GM1702914Courtesy of GENERAL MOTORS CORP.
  5. Reposition the generator battery jumper cable boot (3).
  6. Remove the generator battery jumper cable nut (2) from the generator.
  7. Remove the generator battery jumper cable terminal (1) from the generator stud.
    8. Fig 3: View Of Generator & Bolts
    GM1702916Courtesy of GENERAL MOTORS CORP.
  8. Remove the generator bolts.
  9. Remove the generator.
scientia non olet · About LEMON Manuals