LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2009 >> H3 Alpha >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Battery Hold Down Retainer & Bolt
    GM1702812Courtesy of GENERAL MOTORS CORP.
  1. Install the battery.
    2. NOTE: Refer to Fastener Notice .
  2. Install the battery hold down retainer and bolt.

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

    3. Fig 2: View Of Front Fender Rear Upper Brace & Bolts
    GM1702811Courtesy of GENERAL MOTORS CORP.
  3. Install the front fender rear upper brace and bolts.

    Tighten:  Tighten the bolts to 9 N.m (80 lb in).

    4. Fig 3: View Of Battery Cable Components
    GM1702504Courtesy of GENERAL MOTORS CORP.
  4. Position the starter solenoid cable to the battery.
  5. Install the starter solenoid cable to the positive battery terminal.
  6. Tighten the starter solenoid cable nut (5).

    Tighten:  Tighten the nut to 17 N.m (13 lb ft).

  7. Close the starter solenoid cable cover at the positive battery terminal.
  8. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals