LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2009 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 6.2L - Introduction >> Repair Instructions >> Fuel Tank Filler Hose Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Fuel Fill Hose & Hose Clamps
    GM832912Courtesy of GENERAL MOTORS CORP.
  1. Uncap the fuel tank opening.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the fuel fill hose and the hose clamps to the fuel fill pipe.

    Tighten:  Tighten the clamps to 2.5 N.m (22 lb in).

  3. Clip the fuel fill hose to the plastic retaining clip on the frame.
  4. Lower the vehicle.
  5. Refill the fuel system.
scientia non olet · About LEMON Manuals