LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2009 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 6.2L - Introduction >> Repair Instructions >> Camshaft Position Sensor Replacement >> Removal Procedure

Removal Procedure

NOTE: Clean the area around the camshaft position (CMP) sensor before removal in order to prevent debris from entering the engine.
    Fig 1: View Of Camshaft Position (CMP) Sensor & Bolt
    GM260128Courtesy of GENERAL MOTORS CORP.
  1. Remove the engine sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
  2. Disconnect the CMP sensor electrical connector.
  3. Remove the CMP sensor bolt.
  4. Remove the CMP sensor.
scientia non olet · About LEMON Manuals