LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Base, Standard >> Repair and Diagnosis >> Transmission >> Manual Transmission >> Repair Instructions - On Vehicle >> Control Lever and/or Boot Replacement >> Removal Procedure

Removal Procedure

  1. Remove the shift lever assembly. Refer to Shift Lever Assembly Replacement .
    2. Fig 1: Control Lever Boot
    GM1563256Courtesy of GENERAL MOTORS CORP.
  2. Remove the control lever boot screws (1).
  3. Tilt and remove the control lever boot (2) from the control lever.
  4. Shift the transmission into NEUTRAL.
    5. Fig 2: Control Lever Housing Assembly
    GM1563260Courtesy of GENERAL MOTORS CORP.
  5. Remove the control lever housing assembly bolts (1).
  6. Remove the control lever housing assembly (2) and gasket (3).
  7. Mask off the control lever housing opening, in order to prevent foreign objects from entering the transmission.
  8. Disassemble the control lever housing if necessary. Refer to Shift Control Housing Disassemble .
scientia non olet · About LEMON Manuals