LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 475 (Rear Suspension System) >> Repair Instructions >> Shock Absorber Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Shock Absorber
    GM1209248Courtesy of GENERAL MOTORS CORP.
  1. Install the shock to the vehicle.
    2. Fig 2: Lower Shock Mounting Bolt
    GM926577Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  2. Install the lower shock mounting bolt and tighten to 150 N.m (111 lb ft).
    3. Fig 3: Automatic Level Control Air Line
    GM926578Courtesy of GENERAL MOTORS CORP.
  3. Connect the automatic level control air line to the shock for the F55 suspension, if needed.
    4. Fig 4: Shock Absorber Electrical Connector & Upper Shock Mounting Nuts
    GM925715Courtesy of GENERAL MOTORS CORP.
  4. Guide the shock to the body while lowering the vehicle.
  5. Install the upper shock mounting nuts (2) and tighten to 25 N.m (18 lb ft).
  6. Connect the electrical connector (1) for the F55 suspension, if needed.
  7. Reposition the sound insulator around the shock tower.
  8. Install the trim panel.
scientia non olet · About LEMON Manuals