Installation Procedure

WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Stabilizer Shaft Link & Retaining Nuts

Courtesy of GENERAL MOTORS CORP.

Install the stabilizer shaft link to the vehicle.

NOTE: Do not tighten the nuts at this time.

NOTE: Hold the shaft link studs with the hex tool to prevent damage to the link seal.

Install the stabilizer shaft link lower retaining nut.

CAUTION: Refer to Fastener Caution .

Install the stabilizer shaft link upper retaining nut and tighten to 115 N.m (95 lb ft).
Lower the vehicle.