LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 468 (Mirror System) >> Repair Instructions >> Inside Rearview Mirror Replacement (UE1) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rearview Mirror Mounting Components
    GM787028Courtesy of GENERAL MOTORS CORP.
  1. Position the center bottom of the mirror mount against the windshield at the top of the support button (1).
  2. Slide the base of the mirror onto the button.
    3. CAUTION: Refer to Fastener Caution .
  3. Make sure the mirror is firmly seated on the windshield button by pushing down on the base of the mirror and tighten to 1.8 N.m (16 lb in) in order to secure the mirror base to the button.
  4. Install the base trim cover.
    5. Fig 2: Rearview Mirror Electrical Connector
    GM787027Courtesy of GENERAL MOTORS CORP.
  5. Connect the electrical connector.
  6. Install the wire cover.
  7. Reposition the mirror assembly.
  8. Refer to Control Module References for programming and setup information.
scientia non olet · About LEMON Manuals