LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 467 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Positive Cable Replacement (LLT With Side Post) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the battery positive cable to the engine.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    3. Fig 1: Starter Terminal Nut & Battery Positive Cable
    GM887713Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  3. Connect the battery positive cable (2) to the starter and install the starter terminal nut (1) and tighten to 13 N.m (115 lb in).
    4. Fig 2: Battery Positive Lead & Generator BAT Terminal Nut
    GM887703Courtesy of GENERAL MOTORS CORP.
  4. Connect the battery positive lead (2) to the generator and install the generator BAT terminal nut (3) and tighten to 3 N.m (115 lb in).
  5. Install the protective boot to the generator output BAT terminal.
  6. Lower the vehicle.
    7. Fig 3: Battery Positive Cable To Underhood Fuse Block & Nut
    GM772415Courtesy of GENERAL MOTORS CORP.
  7. Install the nut (1) securing the battery positive cable (2) to the underhood fuse block and tighten to 15 N.m (11 lb ft).
    8. Fig 4: Underhood Fuse Box
    GM785724Courtesy of GENERAL MOTORS CORP.
  8. Install the electrical center cover.
    9. Fig 5: Battery Positive & Negative Cables
    GM772424Courtesy of GENERAL MOTORS CORP.
  9. Connect the battery positive cable to the battery and tighten to 17 N.m (13 lb ft).
  10. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (LHD With Top Post) .
scientia non olet · About LEMON Manuals