LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 467 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Positive Cable Replacement (LH2 With Side Post) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Starter Motor & Connections
    GM1237944Courtesy of GENERAL MOTORS CORP.
  1. Position the battery positive cable to the engine.
  2. Install the positive battery cable to the retaining features on the engine wiring harness bracket.
    3. CAUTION: Refer to Fastener Caution .
  3. Connect the battery positive cable (2) to the starter and install the starter terminal nut and tighten to 10 N.m (89 lb in).
    4. Fig 2: Battery Positive Cable To Underhood Fuse Block & Nut
    GM772415Courtesy of GENERAL MOTORS CORP.
  4. Install the intake manifold. Refer to Intake Manifold Replacement .
  5. Connect the cable retaining clip to the stud.
  6. Install battery positive cable (2) and nut (1) to the underhood fuse block and tighten to 15 N.m (11 lb ft).
    7. Fig 3: Underhood Fuse Box
    GM785724Courtesy of GENERAL MOTORS CORP.
  7. Install the underhood fuse block cover to the underhood fuse block.
  8. Install the wiring harness to the retaining features on the underhood fuse block cover.
    9. Fig 4: Battery Cables, Retaining Clip & Bolt To Shock Tower
    GM1201077Courtesy of GENERAL MOTORS CORP.
  9. Connect the battery positive cable to the battery and tighten to 17 N.m (13 lb ft).
  10. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (Side Post) .
scientia non olet · About LEMON Manuals