Ignition and Start Switch Replacement

WARNING: This page is about a different car, the 2009 GMC Canyon and 2009 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Ignition and Start Switch Replacement

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling . Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection . Remove the lower steering column trim cover. Refer to Steering Column Trim Cover Replacement .
1	Ignition/Start Switch Electrical Connector
2	Ignition/Start Switch Bolt (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten: 0.74 N.m (7 lb in)
3	Ignition/Start Switch Procedure: Turn the ignition lock cylinder to the run position prior to removing the ignition/start switch.