LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 271 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Passenger Presence System Replacement - Front >> Installation Procedures

Installation Procedures

WARNING: This page is about a different car, the 2009 GMC Canyon and 2009 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Seat Cushion Frame Bladder Retainers
    GM811858Courtesy of GENERAL MOTORS CORP.
  1. Install the inflatable restraint passenger presence system to the seat.
  2. Install the push-in retainers (1) that hold the bladder to the seat cushion frame.
    3. Fig 2: View Of Electronic Control Unit & Pressure Switch
    GM811855Courtesy of GENERAL MOTORS CORP.
  3. Install the pressure sensor (2) to the bottom of the passenger seat cushion frame.
    4. CAUTION: Refer to Fastener Caution .
  4. Install the bolts that retain the ECU (1) to the bottom the passenger seat cushion frame.

    Tighten:  Tighten the bolts to 2 N.m (18 lb in).

  5. Connect the electrical connectors.
  6. Install the seat cushion trim cover and pad.
  7. Re-zero the inflatable restraint passenger presence system. Refer to Control Module References .
scientia non olet · About LEMON Manuals