LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 213 (Engine Cooling System) >> Repair Instructions >> Radiator Surge Tank Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the surge tank.
    2. Fig 1: View Of Surge Tank
    GM1334991Courtesy of GENERAL MOTORS CORP.
  2. Connect the low coolant sensor electrical connector.
    3. NOTE: Refer to Fastener Notice .
  3. Install the surge tank nut.

    Tighten:  Tighten the nut to 9 N.m (80 lb in).

  4. Install the surge tank bolt.

    Tighten:  Tighten the bolt to 9 N.m (80 lb in).

    5. Fig 2: View Of Surge Tank Hose
    GM1334992Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Lubricate the inside diameters of the hoses with clean coolant prior to installation.
  5. Connect the surge tank inlet hose to the surge tank.
  6. Using the J 38185  , reposition the hose clamp to secure the surge tank inlet hose. See Special Tools .
  7. Connect the surge tank outlet hose.
  8. Using the J 38185  , reposition the hose clamp to secure the surge tank outlet hose. See Special Tools .
  9. Connect the master cylinder fluid level sensor electrical connector.
  10. Fill the cooling system. Refer to Cooling System Draining and Filling (Static Fill)  or Cooling System Draining and Filling (GE 47716) .
scientia non olet · About LEMON Manuals