LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 166 (Steering Wheel & Steering Column) >> Repair Instructions >> Turn Signal Multifunction Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the multifunction switch electrical connectors.
  2. Install the multifunction switch to the steering column.
    3. Fig 1: View Of Multifunction Switch & Screws
    GM420196Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the retaining screws to the multifunction switch.

    Tighten:  Tighten the screws to 7 N.m (62 lb in).

  4. Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
  5. Enable the SIR system. Refer to SIR Disabling and Enabling .
scientia non olet · About LEMON Manuals