LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 166 (Steering Wheel & Steering Column) >> Repair Instructions >> Steering Column Lock Control Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Steering Column Module
    GM617895Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the control module (1) to the steering column and tighten the retaining screw.

    Tighten:  Tighten screw to 5 N.m (44 lb in).

  2. Connect the electrical connectors on the steering column control module.
  3. Install the knee bolster. Refer to Driver Knee Bolster Bracket Replacement .
  4. Program the steering column control module. Refer to Steering Column Lock Control Module Programming and Setup .
  5. Refer to Control Module References for programming and setup information.
scientia non olet · About LEMON Manuals