LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 126 (Disc Brake System) >> Repair Instructions >> Rear Disc Brake Hardware Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Brake Caliper Components
    GM750472Courtesy of GENERAL MOTORS CORP.
  1. Apply a thin coat of high temperature silicone lube to the brake caliper guide pin boots.
  2. Install the brake caliper pin boots (3) to the brake caliper mounting bracket (4).
  3. Apply a thin coat of high temperature silicone lube to the brake caliper guide pins (2).
  4. Install the brake caliper guide pins (2) to the brake caliper mounting bracket (4).
    5. Fig 2: View Of Brake Pads And Brake Caliper Mounting Bracket
    GM1335587Courtesy of GENERAL MOTORS CORP.
  5. Install the brake pad retainers (2) to the brake caliper mounting bracket (3).
  6. Install the brake pads (1) to the brake caliper mounting bracket (3).
  7. Install the brake caliper to the brake caliper mounting bracket.
    8. Fig 3: View Of Brake Caliper Pin Bolts
    GM1335465Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  8. Install the 2 brake caliper guide pin bolts.

    Tighten:  Tighten the brake caliper guide pin bolts to 35 N.m (26 lb ft).

  9. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  10. Lower the vehicle.
  11. Fill the master cylinder to the proper level. Refer to Master Cylinder Reservoir Filling .
  12. Pump the brake pedal 2-3 times in order to seat the rear disc brake pads to the rotor.
scientia non olet · About LEMON Manuals