LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Cellular System, Entertainment System, And Navigation System) >> Diagnostic Information and Procedures >> Speaker Malfunction >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the appropriate speaker.
  2. Radio ON, test for 5.0-7.5 volts between the signal circuit terminal A (door speaker) or 1 (tweeter) and ground.
    • If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the radio.
    • If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the radio.
  3. Test for 5.0-7.5 volts between the signal circuit terminal B (door speaker) or 2 (tweeter) and ground.
    • If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the radio.
    • If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the radio.
  4. If all circuits test normal, test or replace the speaker.
scientia non olet · About LEMON Manuals