Windshield Wiper Motor Replacement

Fig 1: Windshield Wiper Motor Replacement

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
NOTE: Refer to Fastener Notice . Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .Preliminary Procedure: Remove the front wiper module. Refer to Windshield Wiper System Module Replacement .
1	Bolts, Transmission to Wiper Motor (Qty: 2) Tighten: 10 N.m (89 lb in)
2	Motor, Windshield Wiper Tip: The new wiper motor and crank arm position is pre-set, no crank arm to transmission arm alignment is needed. Use a J 39232 Wiper Transmission Separator or equivalent to remove the transmission linkage from the crank arm. Use a J 39529 Transmission Installer or equivalent to secure the transmission linkage to the wiper motor crank arm.