LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 99 (Wiring Systems And Power Management - Introduction) >> Repair Instructions >> Ignition and Start Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the instrument panel (I/P) cluster. Refer to Instrument Cluster Replacement .
  2. Remove the knee bolster. Refer to Knee Bolster Replacement .
  3. Remove the I/P center trim panel. Refer to Instrument Panel Center Trim Panel Replacement .
  4. Remove the ignition switch wire harness connector.
  5. Remove the theft deterrent module wire harness connector.
  6. Remove the ignition switch lock cylinder. Refer to Ignition Switch Lock Cylinder Replacement .
  7. Disconnect the park lock cable at the ignition switch. Refer to Park Lock Cable Replacement .
  8. Remove the ignition switch at the I/P screws.
    9. Fig 1: View Of Ignition Switch Assembly
    GM1207704Courtesy of GENERAL MOTORS CORP.
  9. Remove the ignition switch assembly.
  10. Remove the ignition switch bracket screws.
  11. Remove the theft deterrent control module. Refer to Theft Deterrent Module Replacement .
    12. Fig 2: View Of Ignition Switch Bracket
    GM1207709Courtesy of GENERAL MOTORS CORP.
  12. Remove the ignition switch bracket.
scientia non olet · About LEMON Manuals