LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 93 (Supplemental Inflatable Restraint System) >> Diagnostic Information and Procedures >> DTC B0022 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: When removing connectors inspect for damage or corrosion. Damage or corrosion in the following requires repair or replacement of the affected component/connector.
  1. Ignition OFF, disconnect the harness connector at the RF inflatable restraint seat belt pretensioner.
  2. Use the appropriate load tool adapter to connect the J 38715-A  to the harness side of the RF inflatable restraint seat belt pretensioner connector. See Special Tools . Use the PASSENGER INFLATOR connector located on the load tool
  3. Ignition ON, with a scan tool, verify the appropriate DTC is set as current.
    • If DTC is not set or is set as history, replace the RF inflatable restraint seat belt pretensioner.
  4. Ignition OFF, disconnect the appropriate load tool adapter and J 38715-A  . See Special Tools .
  5. Disconnect the harness connector at the SDM.
  6. Ignition ON, test for less than 1-volt between the high control circuit terminal 2 and ground.
    • If not within the specified range, test the circuit for a short to voltage.
  7. Test for less than 1-volt between the low control circuit terminal 1 and ground.
    • If not within the specified range, test the circuit for a short to voltage.
  8. Ignition OFF, test for infinite resistance between the high control circuit terminal 2 and ground.
    • If not within the specified range, test the circuit for a short to ground.
  9. Test for infinite resistance between the applicable low control circuit terminal 1 and ground.
    • If not within the specified range, test the circuit for a short to ground.
  10. Test for less then 1 ohm between the RF inflatable restraint seat belt pretensioner terminal 1 and SDM terminal 57.
    • If not within the specified range, test the circuit for an open/high resistance.
  11. Test for less then 1 ohm between the RF inflatable restraint seat belt pretensioner terminal 2 and SDM terminal 56.
    • If not within the specified range, test the circuit for an open/high resistance.
  12. If all circuits test normal, replace the SDM.
scientia non olet · About LEMON Manuals