LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 77 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Link Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Stabilizer Shaft Link Mounting Nut
    GM941489Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not attempt to hold the stabilizer shaft link near the boot. Use the hex feature on the end of the stud. Failure to do so could damage the boot.
  1. Install the stabilizer shaft link.
    2. NOTE: Refer to Fastener Notice .
  2. Install the stabilizer shaft link mounting nuts.

    Tighten: 

    • Tighten the stabilizer bar link lower mounting nut to 44 N.m (32 lb ft).
    • Tighten the stabilizer bar link upper mounting nut to 44 N.m (32 lb ft).

  3. Remove the axle support.
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals