LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 77 (Rear Suspension System) >> Repair Instructions >> Spring Jounce Bumper Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the jounce bumper.
    2. Fig 1: View Of Jounce Bumper Mounting Bolts - RPO Z71
    GM1293767Courtesy of GENERAL MOTORS CORP.
  2. Install the jounce bumper mounting bolts. RPO Z71 suspension.
    3. Fig 2: View Of Jounce Bumper Mounting Bolts - 2WD RPO ZQ8
    GM1293740Courtesy of GENERAL MOTORS CORP.
  3. Install the jounce bumper mounting bolts. 2WD RPO ZQ8 suspension.
    4. Fig 3: View Of Jounce Bumper Mounting Bolts - 4WD
    GM1293742Courtesy of GENERAL MOTORS CORP.
  4. Install the jounce bumper mounting bolts. 4WD base suspension.
    5. Fig 4: View Of Jounce Bumper Mounting Bolts - 2WD
    GM1293765Courtesy of GENERAL MOTORS CORP.
  5. Install the jounce bumper mounting bolts. 2WD base suspension.
    6. NOTE: Refer to Fastener Notice .
    Fig 5: View Of Auxiliary Jounce Bumper Mounting Bolts
    GM1357238Courtesy of GENERAL MOTORS CORP.
  6. Install the auxiliary jounce bumper mounting bolts. 2WD base and RPO ZQ8 suspension.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

    Lower the vehicle.

scientia non olet · About LEMON Manuals