LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 75 (Sunroof System) >> Repair Instructions >> Sunroof Window Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the sunroof window to the module.
    2. Fig 1: Removing/Installing Locker Slider
    GM1774169Courtesy of GENERAL MOTORS CORP.
  2. Install the locker slider (1).
    1. Rotate the lever forward, align the locker slider with the hole in the lever and slider forward.
    2. Using a suitable tool, insert it between the track and the lever to lock it in place.

      The track is not serviceable, if damaged replace the sunroof window.

    3. Fig 2: Removing/Installing Drive Cables
    GM1774163Courtesy of GENERAL MOTORS CORP.
  3. Install the drive cables (1) and sliders (2) to the guides.
    4. Fig 3: Removing/Installing sunroof module guides
    GM1774162Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Using the marks on the left and right sides of the guides to reinstall the window to the module for alignment.
  4. Install the sunroof module guides (1) to the left and right.
  5. Install the sunroof module sliders. Refer to Sunroof Sliding Block Guide Replacement .
  6. Install the sunroof module guides. Refer to Sunroof Guide Replacement .
  7. Verify operations of the sunroof window.
scientia non olet · About LEMON Manuals