LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 71 (Front Drive Axle) >> Repair Instructions >> Front Axle Lubricant Replacement

Front Axle Lubricant Replacement

WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Ensure that the vehicle is level.
  3. Remove the engine protection shield (EPS), if equipped. Refer to Engine Protection Shield Replacement .
  4. Remove the drain plug.
  5. Drain axle fluid into a suitable container.
    6. NOTE: Refer to Fastener Notice .
  6. Install the drain plug.

    Tighten:  Tighten the drain plug to 32 N.m (24 lb ft).

  7. Remove the fill plug.
  8. Fill the drive axle with the proper fluid. Refer to Fluid and Lubricant Recommendations .
  9. Inspect the fluid level. Refer to Front Axle Lubricant Level Inspection .
  10. Install the fill plug.

    Tighten:  Tighten the fill plug to 32 N.m (24 lb ft).

  11. Install the EPS, if equipped. Refer to Engine Protection Shield Replacement .
  12. Lower the vehicle.
scientia non olet · About LEMON Manuals