LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Instrument Panel Trim And Console Trim) >> Repair Instructions >> Driver Knee Bolster Panel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Park Brake Cable Connection
    GM1276399Courtesy of GENERAL MOTORS CORP.
  1. Position the trim panel to the instrument panel (I/P).
  2. In order to install the cable to the trim panel, insert the cable into the trim panel and rotate the cable counterclockwise past the molded bumps (1), until seated.
    3. Fig 2: View Of Park Brake Release Handle & Cable
    GM1276401Courtesy of GENERAL MOTORS CORP.
  3. Install the park brake release handle to the cable ensuring the retaining tabs are fully seated.
    4. Fig 3: View Of Trim Panel
    GM1245530Courtesy of GENERAL MOTORS CORP.
  4. Align the trim panel retaining clips to the I/P.

    Push the trim panel forward into the I/P, seating the retaining clips.

    5. NOTE: Refer to Fastener Notice .
  5. Install the screw retaining the trim panel.

    Tighten:  Tighten the screw to 2.5 N.m (22 lb in).

    6. Fig 4: View Of Hood Release Lever
    GM1277255Courtesy of GENERAL MOTORS CORP.
  6. Install the hood release lever to the trim panel.
    7. Fig 5: View Of Hood Release Lever Screws
    GM1277253Courtesy of GENERAL MOTORS CORP.
  7. Install the hood release lever screws.

    Tighten:  Tighten the screws to 2.5 N.m (22 lb in).

scientia non olet · About LEMON Manuals