LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Interior Trim And Paneling) >> Repair Instructions >> Assist Handle Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the assist handle over the retaining clips.
    2. Fig 1: View Of Assist Handle
    GM1364955Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the assist handle by installing 2 screws and washers into the retaining clips.

    Tighten:  Tighten the assist handle screws to 1.2 N.m (10 lb in).

    3. Fig 2: View Of Coat Hook Assembly
    GM1276792Courtesy of GENERAL MOTORS CORP.
  3. In replacing the entire coat hook assembly, press the coat hook and the retaining clip as an assembly into the sheet metal opening until the clip locks into position.
scientia non olet · About LEMON Manuals