LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 475 (Rear Suspension System) >> Repair Instructions >> Trailing Arm Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Trailing Link
    GM858495Courtesy of GENERAL MOTORS CORP.
  1. Install the trailing link to the vehicle.
    2. Fig 2: Trailing Link-To-Frame Bolt
    GM858493Courtesy of GENERAL MOTORS CORP.
    NOTE: Loosely install the trailing link before tightening.
  2. Install the trailing link to frame bolt.
  3. Install the trailing link to frame nut.
  4. Raise the frame with a suitable jack.
    5. CAUTION: Refer to Fastener Caution .
  5. Install the front bolts to the frame and tighten the bolts to 265 N.m (195 lb ft).
  6. Remove the jack.
  7. Support the lower control arm with a suitable jack for alignment of the trailing link and the knuckle.
    8. Fig 3: Trailing Link-To-Knuckle Bolt
    GM858496Courtesy of GENERAL MOTORS CORP.
  8. Install the trailing link to knuckle bolt.
  9. Install the trailing link to knuckle nut.
    1. Tighten the trailing link to frame nut to 150 N.m (111 lb ft).
    2. Tighten the trailing link to knuckle mounting bolt to 170 N.m (125 lb ft).
  10. Install the brake pipe bracket from the mounting studs.
  11. Install the brake pipe bracket retaining nuts and tighten to 10 N.m (89 lb in).
  12. Install the automatic level control link to the upper control arm.
  13. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  14. Lower the vehicle.
scientia non olet · About LEMON Manuals