Programmable Automatic Door Locks

WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.

If the vehicle has power door locks, it is equipped with a feature that enables you to program the power door locks.

In the programming mode, the driver information center (DIC) will display the following features:

AUTOMATIC LOCKING
AUTOMATIC UNLOCKING
REMOTE LOCK FEEDBACK
REMOTE UNLOCK FEEDBACK

The following instructions detail how to enter the programming mode for the power door lock feature:

With the engine OFF, place the ignition in the LOCK position.
Press the power door lock switch down for 3 seconds.
Press the control stem for more than 2 seconds to view the modes and 1 second to select a mode.
The following is a list of available programming options:
- Mode 1-All doors lock when the vehicle is shifted out of PARK (P) for automatic transmission, or when the vehicle speed is greater than 15 mph (24 km/h) for manual transmission. All doors unlock when the vehicle is shifted into PARK (P) for automatic transmission, or when the key is removed from the ignition for manual transmission.
- Mode 2-All doors lock when the vehicle is shifted out of PARK (P) for automatic transmission, or when the vehicle speed is greater than 15 mph (24 km/h) for manual transmission. Only the drivers door unlocks when the vehicle is shifted into PARK (P) for automatic transmission, or when the key is removed from the ignition for manual transmission.
- Mode 3-All doors lock when the vehicle is shifted out of PARK (P) for automatic transmission, or when the vehicle speed is greater than 15 mph (24 km/h) for manual transmission. None of the doors unlock.