LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 346 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Canyon and 2009 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Stabilizer Shaft Insulator Bracket
    GM941454Courtesy of GENERAL MOTORS CORP.
  1. Install the stabilizer shaft insulators to the stabilizer shaft.
  2. Install the stabilizer shaft.
  3. Install the stabilizer shaft insulator brackets to the rear axle.
  4. Install the stabilizer shaft bracket mounting bolts.
    5. Fig 2: View Of Stabilizer Shaft To Link Nut
    GM1355917Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
    NOTE: Do not attempt to hold the stabilizer shaft link near the boot. Use the hex feature on the end of the stud. Failure to do so could damage the boot.
  5. Install the stabilizer shaft to link nut.
    • Tighten the stabilizer bar link nut to 44 N.m (32 lb ft).
    • Tighten the insulator bracket bolts to 50 N.m (37 lb ft).
  6. Remove the rear axle support.
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals