LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Wiring Systems And Power Management - Introduction) >> Repair Instructions >> Ignition Lock Cylinder Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
  2. Turn the ignition lock cylinder to the accessory position.
  3. Insert the 90 degree tip of a pick type tool into the ignition lock cylinder access hole.
  4. Push and hold the ignition lock cylinder retaining pin down.
  5. Pull the ignition lock cylinder away from the steering column.
scientia non olet · About LEMON Manuals