LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 300 (Disc Brake System) >> Repair Instructions >> Brake Rotor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Canyon and 2009 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Support the brake rotor assembly on wooden blocks to prevent damage to brake rotor friction surface.
    Fig 1: View Of Brake Rotor
    GM1241355Courtesy of GENERAL MOTORS CORP.
  1. Position the wheel hub to the brake rotor.
    2. CAUTION: Refer to Fastener Caution .
    NOTE: Use only hand tools to install the wheel hub bolts.
    NOTE: Ensure the wheel hub and brake rotor are properly mated.
    Fig 2: View Of Wheel Hub/Speed Sensor To Brake Rotor Bolts
    GM1241354Courtesy of GENERAL MOTORS CORP.
  2. While supporting the brake rotor assembly, install the 6 wheel hub bolts and, using only hand tools, tighten the bolts to 120 N.m (89 lb ft).
  3. Install the wheel bearing and hub assembly. Refer to Front Wheel Bearing and Hub Replacement .
  4. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
scientia non olet · About LEMON Manuals