LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Lighting Systems) >> Repair Instructions >> Tail Lamp Bulb Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Tail Lamp Assembly
    GM1376204Courtesy of GENERAL MOTORS CORP.
  1. Install the bulbs to the tail lamp, and/or side marker lamp sockets.
  2. Install the tail lamp sockets to the tail lamp, rotating clockwise until the locking tab is fully seated.
    3. Fig 2: View Of Tail Lamp Screws
    GM1373072Courtesy of GENERAL MOTORS CORP.
  3. Press the tail lamp to the rear body panel until fully seated.
    4. NOTE: Refer to Fastener Notice .
  4. Install the tail lamp screws (1) to the tail lamp.

    Tighten:  Tighten the tail lamp screws (1) to 3 N.m (26 lb in).

  5. Close the tailgate.
scientia non olet · About LEMON Manuals