LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 297 (Engine Control System & Fuel System - 2.9L - Introduction, Service & Repair) >> Repair Instructions >> Fuel Tank Replacement >> Assembly Procedure

Assembly Procedure

WARNING: This page is about a different car, the 2009 GMC Canyon and 2009 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Feed And EVAP Lines
    GM1766211Courtesy of GENERAL MOTORS CORP.
  1. Install the fuel tank module to the fuel tank. Refer to Fuel Tank Module Replacement .
  2. Connect the fuel feed line (2) quick connect fitting to the module. Refer to Plastic Collar Quick Connect Fitting Service .
  3. Engage the fuel feed line to the retaining feature molded into the fuel tank.
  4. Connect the EVAP line (1) quick connect fittings to the module and the vent valve. Refer to Plastic Collar Quick Connect Fitting Service .
  5. Engage the EVAP line to the retaining features molded into the fuel tank.
  6. Install the EVAP line to the clip on the side of the fuel tank.
scientia non olet · About LEMON Manuals