LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 297 (Engine Control System & Fuel System - 2.9L - Introduction, Service & Repair) >> Repair Instructions >> Air Cleaner Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 GMC Canyon and 2009 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Engine Wiring Harness Electrical Connector And Mass Air Flow (MAF)/intake Air Temperature (IAT) Sensor
    GM1969052Courtesy of GENERAL MOTORS CORP.
  1. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
  2. Disconnect the engine wiring harness electrical connector (1) from the mass air flow (MAF)/intake air temperature (IAT) sensor (2).
    3. Fig 2: Secondary Air Injection (AIR) Pump Inlet Hose
    GM1969060Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the secondary air injection (AIR) pump inlet hose (1) quick connect fitting from the air cleaner assembly. Refer to Plastic Collar Quick Connect Fitting Service .
    4. Fig 3: Air Cleaner Assembly
    GM1969156Courtesy of GENERAL MOTORS CORP.
  4. Remove the air cleaner bolts (2).
  5. Remove the air cleaner assembly (1) from the vehicle.
scientia non olet · About LEMON Manuals