LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 297 (Engine Control System & Fuel System - 2.9L - Introduction, Service & Repair) >> Repair Instructions >> Accelerator Pedal Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Canyon and 2009 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of APP Sensor
    GM1352013Courtesy of GENERAL MOTORS CORP.
  1. Position the APP sensor over the studs.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the APP sensor nuts.

    Tighten:  Tighten the APP sensor mounting nuts to 9 N.m (80 lb in).

  3. Connect the APP sensor electrical connector.
  4. Inspect below the pedal for binding, to ensure full range of motion.
scientia non olet · About LEMON Manuals