Installation Procedure
WARNING: This page is about a different car, the 2009 GMC Canyon and 2009 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
- Position the generator to the engine.
- Install the engine lift bracket. Refer to Engine Lift Bracket Replacement or Engine Lift Bracket Replacement .
- Install the generator mounting bolts and tighten in sequence to 50 N.m (37 lb ft).
- Connect the generator lead (5) to the generator and install the generator output BAT terminal nut (6).
Tighten the nut to 20 N.m (15 lb ft).
- Press the protective boot (4) on to the generator output BAT terminal (2).
- Connect the wiring harness connector (1) to the generator.
- Raise and support the vehicle only high enough to access the A/C compressor through the wheelhouse. Refer to Lifting and Jacking the Vehicle .
- Position the A/C compressor (1) to the engine.
- Install the A/C compressor mounting bolts (2, 3) and tighten to 50 N.m (37 lb ft).
- Attach the A/C compressor electrical connector to the bracket.
- Install the left wheelhouse liner. Refer to Front Wheelhouse Liner Replacement .
- Install the left front wheel. Refer to Tire and Wheel Removal and Installation .
- Lower the vehicle.
- Install the drive belt. Refer to Drive Belt Replacement or Drive Belt Replacement .
- Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
CAUTION:
Refer to Fastener Caution
.