LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Battery, Charging System And Starting System) >> Repair Instructions >> Generator Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
    2. Fig 1: View Of Battery Cable Harness Retainer
    GM1313637Courtesy of GENERAL MOTORS CORP.
  2. Open the battery cables harness retainer (3).
    3. Fig 2: Locating Positive Cable
    GM1313640Courtesy of GENERAL MOTORS CORP.
  3. Press the locking tabs inward in order to remove the underhood fuse block cover from the underhood fuse block.
  4. Remove the nut (2) securing the generator positive cable (5) to the underhood fuse block (1).
    5. Fig 3: View Of Generator Wiring Components
    GM1313641Courtesy of GENERAL MOTORS CORP.
  5. Reposition the protective boot (4) from the generator output BAT terminal (2) for access.
  6. Remove the generator output BAT terminal nut (6) and disconnect the generator positive lead (5) from the generator.
  7. Remove the generator positive cable (3) from the battery cables harness conduit.
scientia non olet · About LEMON Manuals