LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 219 (Suspension Control System - Automatic Level Control) >> Diagnostic Information and Procedures >> DTC C0696 >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a 3A fused jumper wire between the 5-volt reference terminal A and a external 5-volt power source. Install a jumper wire between the low reference terminal C and ground.
  2. Sweep the suspension position sensor through the entire range while monitoring the voltage between the signal terminal B and the low reference terminal C. The range should vary between 0.35-4.75 volts without any spikes or dropouts.
    • If not within the specified range or if it is erratic, replace the applicable suspension position sensor.
scientia non olet · About LEMON Manuals