LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 178 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Current Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Instrument Panel (I/P) Harness Electrical Connector
    GM1484712Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the instrument panel (I/P) harness electrical connector (1) from the battery current sensor.
  2. Remove the negative battery cable. Refer to Battery Negative Cable Replacement (LC3)  or Battery Negative Cable Replacement (LH2)  or Battery Negative Cable Replacement (LY7) .
    3. Fig 2: View Of Battery Current Sensor
    GM1475086Courtesy of GENERAL MOTORS CORP.
  3. Cut the tie straps and electrical tape attaching the battery current sensor to the battery cable.
  4. Squeeze the negative battery cable branches together.
    5. IMPORTANT: Note the position of the battery current sensor prior to removal.
  5. Slide the battery current sensor (1) off of the negative battery cable.
scientia non olet · About LEMON Manuals