LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 168 (Cellular System, Entertainment System, And Navigation System) >> Repair Instructions >> Cellular Communications/Digital Radio Antenna Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Antenna Assembly
    GM1491976Courtesy of GENERAL MOTORS CORP.
  1. Install the antenna to the roof.
    2. Fig 2: View of Digital Radio Antenna Connectors, Bolt, Expansion Sleeve, and Retainer
    GM863301Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Route the wiring pigtail to the side in the slot on the antenna shaft and install the antenna expansion sleeve (3) and bolt (2) to the antenna shaft.

    Tighten:  Tighten the bolt to 9 N.m (80 lb in).

  3. Connect the antenna connectors (1).
  4. Wrap the connectors (1) with foam tape.
  5. Install the antenna cable connection above the AM/FM antenna module.
  6. Install the antenna cable hold down clips.
  7. Align the headliner to the roof panel.
  8. Install the rear sail panels. Refer to Sail Panel Replacement .
  9. Locate the mast to the antenna base.
  10. Install the screws securing the mast to the antenna base.

    Tighten:  Tighten the screws to 1 N.m (9 lb in).

scientia non olet · About LEMON Manuals