LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 157 (Fixed & MOVEABLE Window Systems) >> Repair Instructions >> Front Side Door Window Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Front Window Regulator Clamp
    GM758771Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The window regulator should be at least 1/2 way down before installing the window.
  1. Position the window down into the door.
  2. Locate the window into the 2 window regulator clamps.
    3. IMPORTANT: Start the vehicle to ensure maximum power to the window motor. This is required in order to fully seat the window for adjustment.
  3. Start the vehicle.
    4. NOTE: Refer to Fastener Notice .
  4. Using the power window switch, raise the window to the fully closed position.

    Tighten:  Tighten the window clamp nuts to 11 N.m (98 lb in).

  5. Inspect for proper window operation and a tight seal.
  6. Shut off the vehicle.
  7. Install the water deflector. Refer to Front Side Door Water Deflector Replacement .
  8. Install the door control module. Refer to Door Control Module Replacement .
  9. Install the door trim panel. Refer to Front Side Door Trim Panel Replacement .
scientia non olet · About LEMON Manuals