LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 113 (Front Suspension System) >> Repair Instructions >> Wheel Stud Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Wheel Stud - 5-Stud Pattern
    GM1233046Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  3. Remove and support the brake caliper and bracket as an assembly, and remove the brake rotor. Refer to Front Brake Rotor Replacement .
  4. Rotate the bearing hub to a position where the least amount of interference between the stud and the steering knuckle exists.
  5. Using the J 43631  , release the wheel stud from the bearing hub and discard the stud. See Special Tools .
scientia non olet · About LEMON Manuals