LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 113 (Front Suspension System) >> Repair Instructions >> Stabilizer Shaft Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the front tires and wheels. Refer to Tire and Wheel Removal and Installation .
    3. Fig 1: View Of Stabilizer Link And Stabilizer Shaft
    GM1229970Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the stabilizer links from the stabilizer shaft. Refer to Stabilizer Shaft Link Replacement .
  4. Using a suitable jack stand, support the rear of the frame assembly.
  5. Remove the frame support to body bolts.
  6. Remove the rear frame assembly mounting bolts.
  7. Lower the rear of the cradle in order to gain clearance to the stabilizer shaft.
    8. Fig 2: Identifying Frame Support To Body Bolts
    GM1229967Courtesy of GENERAL MOTORS CORP.
  8. Remove the stabilizer bar clamps and insulators. Refer to Stabilizer Shaft Insulator Replacement .
  9. Remove the stabilizer shaft through the opening between the frame and body.
scientia non olet · About LEMON Manuals