LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 113 (Front Suspension System) >> Repair Instructions >> Stabilizer Shaft Link Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Stabilizer Link At Strut Assembly
    GM851723Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Connect the stabilizer link to the strut assembly.

    Tighten:  Tighten the stabilizer link nut to 65 N.m (48 lb ft).

    2. Fig 2: View Of Stabilizer Link And Stabilizer Shaft
    GM1229970Courtesy of GENERAL MOTORS CORP.
  2. Connect the stabilizer link to the stabilizer shaft.

    Tighten:  Tighten the stabilizer link nut to 65 N.m (48 lb ft).

  3. Install the front wheel. Refer to Tire and Wheel Removal and Installation .
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals