LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Cellular System, Entertainment System, And Navigation System) >> Repair Instructions >> Antenna Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the right front door sill plate. Refer to Front Side Door Sill Plate Replacement .
  2. Remove the right hinge pillar trim panel. Refer to Body Hinge Pillar Trim Panel Replacement - Left Side .
  3. Remove the instrument panel (I/P) compartment door. Refer to Instrument Panel Compartment Door Replacement .
    4. Fig 1: View Of Radio Extension Cable
    GM1363155Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the radio antenna cable (1) from the extension cable.
  5. Remove the grommet from the hinge pillar in an outbound direction.
  6. Attach a mechanics wire to the to the antenna cable (1).
  7. Remove the antenna mast. Refer to Fixed Antenna Mast Replacement .
    8. Fig 2: View Of Antenna Base & Screws
    GM1338048Courtesy of GENERAL MOTORS CORP.
  8. Remove the screws retaining the antenna base.
    9. Fig 3: Locating Routing Hole Grommet
    GM1358256Courtesy of GENERAL MOTORS CORP.
  9. Remove the grommet (1) and cable from the routing hole.
  10. Remove the antenna cable from the vehicle.
  11. Leave the mechanics wire in place for assembly purposes.
scientia non olet · About LEMON Manuals