LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 106 (Sunroof System) >> Repair Instructions >> Sunroof Water Gutter Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply a double layer of masking tape to the roof panel along the rear edge of the sunroof opening.
  2. Cycle the sunroof window to the vent position, then to 25 mm (1 in) rearward.
    3. Fig 1: View Of Sunroof Module
    GM1222469Courtesy of GENERAL MOTORS CORP.
  3. Remove the sunroof module assembly. Refer Sunroof Module Assembly Replacement .
    4. Fig 2: View Of Screws That Secure Water Gutter
    GM1224097Courtesy of GENERAL MOTORS CORP.
  4. From the underside of the sunroof window track assembly, remove the 3 screws that secure the water gutter to the forward cross-member of the track assembly.
    5. Fig 3: View Of Water Gutter And Track Assembly
    GM1224100Courtesy of GENERAL MOTORS CORP.
  5. Pull downward on the front edge of the water gutter to allow standing bosses to clear the cross-member. Slide the water gutter rearward to release the retaining tabs from the slots on the track assembly.
  6. Remove the water gutter from the track assembly.
scientia non olet · About LEMON Manuals