LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 106 (Sunroof System) >> Repair Instructions >> Sunroof Motor/Actuator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Sunroof Motor/Actuator Assembly
    GM1222467Courtesy of GENERAL MOTORS CORP.
  1. Position the sunroof motor to the sunroof module.
  2. Push the sunroof motor straight upward to engage the drive gear between the cables housed within the sunroof cable drive tubes.
    3. NOTE: Refer to Fastener Notice .
  3. Install the sunroof actuator screws to the sunroof actuator.

    Tighten:  Tighten the screws to 4 N.m (35 lb in).

    4. Fig 2: Identifying Sunroof Motor/Actuator Electrical Connector
    GM1344700Courtesy of GENERAL MOTORS CORP.
  4. Connect the electrical connector to the sunroof motor.
  5. Install the headliner. Refer to Headlining Trim Panel Replacement (Sedan) .
  6. Initialize/teach the sunroof motor. Refer to Sunroof Motor/Actuator Initialization/Teach Process (New Motor)  or Sunroof Motor/Actuator Initialization/Teach Process (Existing Motor) .
  7. Inspect the sunroof for proper operation.
  8. Refer to Control Module References for programming and setup information.
scientia non olet · About LEMON Manuals