LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 102 (Engine Cooling System) >> Repair Instructions >> Water Pump Replacement (LZ4) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Water Pump, Bolts & Gasket
    GM1557689Courtesy of GENERAL MOTORS CORP.
  1. Position a NEW water pump gasket and the water pump to the engine front cover.
    2. NOTE: Refer to Fastener Notice .
  2. Install the water pump bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

    3. Fig 2: View Of Water Pump Pulley & Bolts
    GM1557687Courtesy of GENERAL MOTORS CORP.
  3. Install the water pump pulley and bolts.
  4. Install the drive belt. Refer to Drive Belt Replacement .
  5. Tighten the water pump pulley bolts.

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

  6. Fill the cooling system. Refer to Cooling System Draining and Filling (L61) .
  7. Inspect for leaks.
scientia non olet · About LEMON Manuals