LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Supplemental Inflatable Restraint System) >> Diagnostic Information and Procedures >> DTC B0092 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: If the PPS has any current or history DTC stored, you must address the PPS DTC before continuing with this diagnostic procedure.
  1. With the scan tool, check for PPS DTC. Refer to Passenger Presence System Flash Code Procedures .
  2. Inspect the PPS and passenger seat inline connector for corrosion or damage.
    • If any of the above conditions are found, make the appropriate repair.
  3. Test the voltage circuits for the PPS for a short to ground or open/high resistance.
    • If any of the above conditions are found, make the appropriate repair.
  4. Reconnect all components, with ignition ON use the scan tool to clear DTC. Recheck for DTC. When all PPS faults have been repaired, rezero the PPS.
  5. Verify that DTC B0092 does not set as a current DTC. If DTC B0092 does set as a current DTC, replace and rezero the PPS.
    • After replacement and the rezeroing of the PPS are completed, perform the repair verification.
scientia non olet · About LEMON Manuals