LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Base, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Headlights >> Lighting >> Repair Instructions >> Fog Lamp Aiming >> Aiming Procedure

Aiming Procedure

    Fig 1: Locating Alignment Points On Target Screen
    GM276650Courtesy of GENERAL MOTORS CORP.
  1. Park the vehicle 7.6 m (25 ft) away from the target screen.
  2. Measure from the center of the fog lamp to the ground line. Using this measurement, mark the horizontal centerline (2) of the fog lamp on the target screen directly in front of the vehicle.
  3. The adjustment hole is located in the front fascia just above the fog lamp assembly.
  4. Turn ON the fog lamps. The top of the fog lamp beam image (4) on the target screen should be 102 mm (4 in) below the center of the fog lamp lens height.
  5. Adjust the fog lamp as required using the adjusting screw at the bottom side of the fog lamp assembly.
  6. Turn OFF the fog lamps.
scientia non olet · About LEMON Manuals